Fleetbridge FRT-2275 User GuideUpdated 3 months ago
Installation
- Choose a mounting location with a clear view of the sky and good signal reception. Avoid metal surfaces or enclosed spaces.
- Power Supply: Connect the red wire to the vehicle's positive power line (12V/24V system compatible) and the black wire to the vehicle's ground line.
- Ignition Detection (optional): Connect the white wire (recommended) to the vehicle's "RUN" ignition switch position.
- Verify Installation: Check the LED light status (refer to the table below for details).
LED Status Lights
| LED | Color | Description |
|---|---|---|
| CELL | Green | Cellular network status: |
| Searching | ||
| Registered | ||
| SIM PIN required | ||
| GPS | Blue | GPS status: |
| Off | ||
| Error | ||
| Searching | ||
| Found | ||
| On (solid) | ||
| PWR | Red | Power status: |
| Battery only (above 3.5V) | ||
| Charging backup battery | ||
| Fully charged |
Smart Charging
The FRT-2275 utilizes smart charging to optimize battery life:
- Power Saving Mode (Ignition Off): Minimizes battery consumption by reporting once a day.
- Backup Battery Charging Mode (Ignition On): Focuses on charging the internal battery.
- Low Battery Protection: Charges the device if battery drops below 30% (even with ignition off) to prevent depletion.
Important Note: Regularly use and charge your motorcycle to maintain battery health despite smart charging.
Safety Information
- Do not disassemble the device.
- Avoid extreme temperatures, high humidity, and direct sunlight.
- Do not use the FRT-2275 on airplanes or near medical equipment.